user manual

ND-20292
CHAPTER3
APRIL, 1990
KFY FUNCTION (OFF I INF!
.SPKR - ON/OFF Line
TEL # - Selects station to be programmed
F/W (Forward) - Increments station number
CLEAR -
ENTER - Enters assignment to each station
B/W (Backward) - Decrements the station number
GUIDE TO FEATURE PROGRAMMING
~~
All CPU levels. (See Step 5.)
NOTES:
1 During step 4, the display shows the current
assignment of the station.
2. DIGIT CODE FEATURE
1
Prime Line
2 Ringing Line
3 Prime/Ringing
4
SLT CO Prime Line
0
Not Set
3. For ETE-6-( 1 and ETE-GD-( 1 Multiline
Terminal, LK 1 - 6 should be used.
4. Depressing the ENTER key. causes the display to
increment to the next station number.
5. Ringing line preference takes priority over
prime line when both are assigned.
6. SLT CO Prime Line can be assigned to stations
supported by SLI or VMI ports only.
7. For Single Line Telephones, an access code must
be programmed for CO release if internal dial
tone is required (M.B. 2El Access code item 931.
i
GENERAL INFORMATION - PRIME/RINGING LINE ASSIGNMENT
I
i
I
I
i
! This area of the memory block is used to assign prime line and/or ringing line preference to all Multiline i
f Terminals and to assign CO Prime Line or Extension Prime Line to SLTs. When prime line or prime/ringing f
i line feature is chosen, a line key must be selected (depressed) for each station.
i
i
i
i._._._.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.- -._.-.-.-._._.-._._._._._._._._._._._._.-.-.-.-.~
>;
300 - 31