user manual

ND-20292
CHAPTER 3
APRIL, 1990
MEMORY BLOCK lE3 - TERMINAL BUSY ASSIGNMENT
OPERATION - AND -W DISPLAY
1. Go off line.
2. Depress Fl, then FlO.
3. Depress F13 (See Note 1).
4. Enter station number to change it’s busy out TERMoBUSY
IN/OUT
status. Example: Station 104.
TEL104
5.
6.
7.
8.
Depress line key Ll to assign the desired status to the terminal. (See Note 2).
Depress ENTER key. (See Notes 3 & 4).
To access port area, depress L13.
TERMoBUSY IN/OUT
To change the port’s busy out status, enter
MOD?
SLOT* CH*
module(l-4),slot(l-8), andport(l-4)numbers. T E R M . B u s y
Example: Module 1, Slot 8, Port 1.
IN/OUT
MOD1
SLOT8 C H 1
9
10
11
Depress Ll to change the status of the selected port. (See Note 2).
Depress ENTER key. (See Notes 3 8z 4).
I
l’o access DSWBLF area, depress L14.
12
13.
14.
15
Enter DSS/BLF number l-6 tochange its busy out T E R M l B U S Y
IN/OUT
status. Example: DSS/BLF 2.
DSS/BLF2
Depress Ll to change the status of the selected DSS/BLF. (See Note 2).
Depress ENTER key. (See Notes 3 8z 4).
To access modem area, depress L12.
(CPU-EB or higher).
16
17.
18.
19.
Enter modem number (l-4) tochange its Busy Out T E R M l B U S y
IN/OUT
status. Example: MODEM 1
MODEM1
Depress Ll to change the status of the selected modem. (See Note 2).
Depress ENTER key. (See Notes 3 & 4).
Depress TEL # key and repeat steps 4 through 18 as required to access a specific port or device to check
and/or change its busy out status.
OF F - LINE (X-XX)
PROGRAM MODE
TERMINAL
ASSIGN
TERMoBUSY IN/OUT
TEL???
TERM.BUSY
IN/OUT
DSS/BLF?
TERM*BUSY IN/OUT
MODEM?
20. Depress SPKR key to go back on line.
300 - 54