user manual

ND-20292
CHAPTER 3
APRIL, 1990
KFY FUNCTION (OFF I INF!
SPKR - ON/OFF Line
TEL # - Selects trunk to be assigned
F/W - Increments trunk number
CLEAR - Clears previous assignment
ENTER - Enters each assignment
B/W - Decrements trunk number
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
‘ROGRAMMED MUST BE PROGRAMMED HAVE TO BE PROGRAMMED
1 D8,2B3,3A4
2B4
CPU-EBB or higher.
NOTES:
1.
2.
3.
4.
5.
6.
7.
There is no default assignment but any
previous extension number that was set will be
displayed.
Depressing the ENTER key will increment the
display to the next trunk.
Extension numbers available = 100 - 899
1000 - 8999
DIT trunks and the terminals where they are
terminated should be assigned to the same
tenant.
DIT trunks do not have to be assigned to line
keys (LKl - LK15) unless the trunk is also being
used for outgoing calls.
DIT and ANA can be assigned to primary,
secondary, or virtual extensions, however, they
cannot be assigned to a uniform dialing number.
Trunk groups associated with DIT or DID trunks
will not activate the External Chime or External
Ring contacts on the ECR-E ETU.
I
I
i
GENERAL INFORMATION - DIT/ANA ASSIGNMENT
i
I I
i i
i This area of the memory block is used to independently assign day mode and night mode (ANA) extension i
t terminations to incoming trunk calls. A trunk can terminate at one extension only, but several trunks can :
i be terminated at the same extension.
I
i
I
L.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.~
300 - 93