user manual

ND-20292

CHAPTER 3

APRIL, 1990

KFY F-OFF I INF!

SPKR - ON/OFF Line

,TEL # - Changes Assignment

B/W -

L,..

CLEAR -

R - Enters assignment

GUIDE TO FEATURE PROGRAMMING

MEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY

‘ROGRAMMED MUST BE PROGRAMMED HAVE TO BE PROGRAMMED

lD7

2B5,286

2B9

i 7..

CPU-EB or higher.

NOTES:

After Step 3 line key LED’s 2 thru 8 will display

the previous assignment. LEDs 2 thru 8

correspond to trunk access code group 2 thru 8.

Ll LED is always off and cannot be changed.

Attempting to do so results in error tone.

Reorder tone is received by a station assigned

for LCR when that station dials an access code

not assigned to by-pass LCR.

Once ENTER is depressed, no further changes

can be made. If new changes are required

depress F19 again or TEL# key to re-enter the

memory block.

‘~.~‘~.~.~‘~.~.-.~‘~.~.~.~.~.~.~.~.~.-.-.~.~.~.~.~.~.~.~.~.~.~.-.~.~.~.~.~.~.~.-.~.~.~.~.~.~.~.~.~.~.~.~.~.~.~.,

GENERAL INFORMATION - LCR BYPASS ASSIGNMENT

i When dialing a station assigned for LCR, this area of the memory block is used to assign (system wide) i

i whether or not Trunk Access Code Groups 2 thru 8 will bypass LCR.

i..-.-.-.-. -.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.

300 - 103