user manual

ND-20292
CHAPTER 3
APRIL, 1990
KEY FUNCTION (OFF LINE)
SPKR - ON/OFF Line
I
CLEAR - Clears ass1
GUIDE TO FEATURE PROGRAMMING
r I 1
MEMORY BLOCK BEING MEMORY BLOCK THAT
MEMORY BLOCK THAT MAY
PROGRAMMED MUST BE PROGRAMMED HAVETO BE PROGRAMMED
I
I I
I
All CPU levels. (See Note 2.)
NOTES:
1. Although there are a total of 10 relays (l- lo),
relays l-3 are permanently assigned to External
Page zones l-3.
During step 4, any previously assigned function
for the selected relay will appear. If there was
no previous assignment, the display will show
VACANT.
2. If Ll (Night Chime) isdepressed, a number, l-3,
must be entered. If L2 (External Ring) is
depressed, a number, l-4 must be entered.
3. If L3 (Delay Announce) is depressed, no
additional digits are required; proceed with step
7. (CPU-EB3 only)
4. With a CPU-EC4 (or higher revision level) LK3
and LK4 can be used for 1st and 2nd Delay
Announcement.
l-7 I”“” l-i-1
I
5. Trunk groups associated with DIT or DID
trunks will not activate the External Chime or
External Ring contacts.
6. Depressing the ENTER key will cause the
display to increment to the next relay number.
i
I
I
GENERAL INFORMATION - ECR RELAY ASSIGNMENT
I
i I
i This area of the memory block is used to assign either Night Chime (l-3), External Ringing Control (l-4)) 1st j
i Delay Announcement or 2nd Delay Announcement functions to control relays 4-10. Relays 1-3 have a fixed
f
i assignment to External Page zones 1 - 3.
i
I i
i.-.-.,.-.-.-.-.-.-.-.-.-. -.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-,-.-.-.-.-.-.-.-,-,-.-.~
300 - 123