user manual

ND-20292
CHAPTER 1
APRIL, 1990
DISPLAY
LCD INDICATIONS (Continued)
LOCATION DEFINITION
MFR2 BUSYOUT
DATA OFF MODEM 3
DATA FROM 123
DATA OFF
Attendant
Calling/Called Station
Receiving Station
Calling/Called Stations
Confirmation of MFR Busied Out
End of Data Communication by ER (Equipment
Ready) Signal Going Off.
Receiving a Data Call
End of Data Switching by DTR (DATA
Terminal) Signal Going Off
CO12 NOT INSTALL
CO11 NORMAL
Attendant Confirmation of Line Test (For Lines Not
Installed)
Attendant
I
Confirmation of Line Test (For Lines Installed)
CO11 BUSY Attendant
I
Confirmation of Line Test (For Lines In Use)
I
MODEM HELD 123 Modem Station Reserving Modem. Indication on Multiline
Terminal dedicated to the Modem.
CO11 BUSYOUT
RESERVED MODEM 3
DATA TO MODEM3
Attendant
Originator
Originator
Confirmation of Line Busied Out
Modem Reserved.
Modem is Being Activated
DIT CALL
3 Ring Assigned Station In use station receiving DIT or ANA call; (3) are
in Queue
NOTE: LCD Displays shown in BOLD /TALK in this chart FLASH on the terminals LCD.
SECTION 160
FEATURE ACCESS CODES (NUMBERING PLAN)
160.1 Codes Dialed While Receiving Dial Tone or Feature Access Tone
FEATURE CONDITION
CODE
(Set in Default)
Call to Attendant
Fixed
0
Extension Numbering (3 or 4 digit) Flexible xxx or xxxx
Uniform Dialing Network
Flexible NONE
Call Forward-All Calls:
Station
Confirm Flexible 41
Set Flexible 41 xxx
Cancel Flexible 41)
Call Forward-Busy/No Answer:
Station Confirm Flexible
42
Set Flexible 42 xxx
Cancel Flexible 42*
Call Forward-All Calls:
Attendant
Confirm Flexible 44
Set Flexible 44 xxx yyy
Cancel
Flexible
44 YYY *
Call Forward-Busy/No Answer:
Attendant Confirm Flexible 45 xxx
Set Flexible 45 xxx yyy
Cancel Flexible 45 xxx *
100 - 20