user manual

ND-20292
CHAPTER 3
APRIL, 1990
ENTER - F”.nt.m-s rninrtion
IB/W - Decrements to current code
I
GUIDE TO FEATURE PROGRAMMING
1 I
I
MEMORY BLOCK BEING
PROGRAMMED
t
I
3E3
MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
MUST BE PROGRAMMED HAVE TO BE PROGRAMMED
lD7
lD6,1ElO,ZA9
2Cl-2C3,3El,
3E2,3E4-3ElO
4Blor4B6
All CPU levels.
NOTES:
1. During step 3 the display shows any current
entry for code 1.
2. Depressing the ENTER key causes the display
to increment to the next entry location.
3. Up to four single digit rejection codes can be
assigned.
I
1
I
I
I
GENERAL INFORMATION - REJECTION CODE ASSIGNMENT
I
I
I
i This area of the memory block is used to assign up to 4 single digit Rejection Codes.
The Rejection Code is i
i used to prevent a code restricted station from bypassing the dialing restriction by first dialing out a i
i sequence of single digits. i
I
i
L .-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.~
300 - 179