user manual

ND-20292
CHAPTER 3
APRIL, 1990
KEY FUNCTION (OFF LINE)
SPKR - ON/OFF Line
TEL # - Enters new table number
F/W - Increments table number
CLEAR - Clears code
ENTER - Enters each code
B/W - Decrements table number
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
PROGRAMMED
MUST BE PROGRAMMED
HAVE TO BE PROGRAMMED
lD6,1D7
2A9,2Cl-2C3,
3E9
3E5,3E6 3El-3E4,3E7,
3E8,3ElO
4Blor4B6
I
llEl0
I
All CPU levels.
NOTES:
1.
2.
3.
4.
5.
6.
During step 4 the display shows any current
area and office code assigned to the code number
and table chosen.
Each table can have a maximum of 8 code
numbers (entries).
Depressing the ENTER key causes the display to
increment to the next code number in the table.
The * key is used to enter three *‘s in the area
and/or office code positions. These three *‘s
represent any digits dialed, from 1 - 0, *, and #.
The # key is used to enter blanks in the office
and area code position areas. (Blanks (-1 are
shown in the corresponding positions).
Any time an area code is programmed, blanks
cannot be left in the office code position.
i
i
GENERAL INFORMATION - RESTRICTION TABLE CODE ASSIGNMENT
j
I i
i This area of the memory block is used to program area and office codes into the system code restriction tables. i
i There are 32 code tables available and each table can hold up to 8 area and office codes.
I
L ._._._._.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-. A
300 - 191