user manual

F/W (Forward) - Increments channel number
,-ENTER - Enters each assignment
B/W (Backward) - Decrements channel number
GUIDE TO FEATURE PROGRAMMING
I
MEMORY BLOCK
MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
BEING PROGRAMMED
I
MUST BE PROGRAMMED
I
HAVE TO BE PROGFSMMEO
I
1 4B2
I
14B1,4B6,4B7,
All CPU levels.
NOTES:
LINE BUTTONS
I
1 3 3 4 IHP)
5 -6 7 -8 ( ) MULTIPLIER
9 -10 -11 -12 0 (Ml
-13 L14 Lib ,lb (IDI)
Multinlier = M Multinlier = M
HP (Hit Protection) Time = 50 mS. x M
(Default: 350 mS.1
DR (Disconnect Recognition) Time = 100 mS.x M
(Default: 300 mS.1
PS (Pause) Time = 500 mS. x M
(Default: 1000 mS.1
ID1 (Interdigit Interval) Time = (10 mS. x Ml
+ 40 mS. (Default: 70 mS.1
ND-20292
CHAPTER 3
APRIL, 1990
1. It is recommended that 4B7 be programmed prior to
4B2, since 4B7 programming overrides all 4B2
programming already done for all the trunks within
that trunk group.
2. During step 6 the status of Ll to L16 will indicate the
previous parameters set to the CO1 port (See chart).
3. See Section 350 for definitions and additional
information.
4. Depressing the ENTER key causes the display to
increment to the next channel, or the first channel of
the next slot containing a COI-E ETU.
r’
-‘-‘-.-.-.-.-‘-.~.~.~.~.~.~.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.~.~.~.-.~.-.-.-.-.-.~.-.-.-.~.~.~.-.,
i
GENERAL INFORMATION - COI-II INITIALIZED VALUES
i
i i
i This area of the memory block is used to assign timing parameters to each CO1 port. For a description of each i
i parameter, see section 350.
i
L._._._._._._._._._._.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.j
300 - 201