user manual

ND-20292
CHAPTER 3
APRIL, 1990
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
PROGRAMMED MUST BE PROGRAMMED HAVE TO BE PROGRAMMED
I I I
I
All CPU levels (See Note 1).
NOTES:
1. During step 5 the display will show the
previous ES1 path assignment for the ES1 ports
chosen. Although a slot associated with an ESI-
EA ETU can be accessed and will display it’s
f:
ath assignment, no assignments can actually
e changed. See figure below:
Ll L2
L3 L4
L5 L6
L7 LS
OFF OFF
OFF ON
ON OFF
ON ON
Channel 1
Channel 2
Channel 3
Channel 4
Single Voice Path
Dual Voice Path
Data (CPU-EB or higher)
Data and Dual Voice
(CPU-EB or higher)
I
2. Only Channels 1 and 3 can be assigned for both data and dual voice path. For this to be done, the next
adjacent channel(s) (Channel 2 and/or Channel 4) must be assigned single voice only, however, data and
single voice can be assigned to all four channels.
3. ETE-6-( ) or ETE-16-2 Multiline Terminals are not compatible with data or dual path features.
4. Depressing the ENTER key will cause the display to increment to the next ES1 slot.
~.-.~‘~.-.~‘~.-.-‘~.-.-.~.~.~.~.~.-.~.~.~.-.-.~.~.-.-.~.-.~.-.~.~.-.-.-.~.~,-.-.~,~.~,~.~.~.~.~.~.~.~.~,~.-.-.-.-.,
i
i
GENERAL INFORMATION - ESI-EB DATA AND SECOND VOICE PATH ;
i ASSIGNMENT i
I
i
i This area of the memory block is used to assign data capability and/or a second voice path to an ESI-EB port. i
i Multiline Terminals assigned a dual path are able to receive a voice page while off-hook. All dual path 1
! terminals have to be equipped with a Dual Path Adaptor (DPA-E), and assigned to an ESI-EB ETU. All !
! stations assigned for data capability must be equipped with a data adapter (DTA-El and assigned to an ESI- i
! EB ETU in CCUs 1 through 3.
L.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-,-.-.-.-.-.-.-.-.-.-.-.-.-.-.~
300 - 205