user manual

ND-20292
CHAPTER 3
APRIL, 1990
MEMORY BLOCK 4B8 - VMI INITIALIZE 1 ASSIGNMENT
j ->
1’
OPERATION
1. Co off line.
2. Depress F4, then F7.
CARD
MODE
3. Depress F18.
f--------D- DISPLAY
OF F - LINE (X-XX)
PROGRAM MODE
.V M I INITIAL lZE1
MOD? SLOT* CH*
4. Dial the module number to be assigned.
VMl
INITIAL IZEl
Example: Module 1.
<MOD 1 SLOT? CH*
5. Dial the slot number to be assigned.
Example: Slot 7.
VMI
INITIAL lZE1
MOD 1 SLOT7 C H ?
6. Dial the channel number to be assigned.
VM I INITIAL IZEl
Example: Channel l.(See Note 1).
MOD 1
SLOT 7 C H 1
NOTE: The following conditions apply when either the first or second VMI-E ETU is entered.
Channel 1 affects VMI-E Ports land5
Channel 2 affects VMI-E Ports 2and6
Channel 3 affects VMI-E Ports 3and7
Channel 4 affects VMI-E Ports 4and8
(CPU-EC4 or higher revision is required to support two VMI-E ETUs)
7. Depress Ll to L12 to set the desired timing parameters of the selected VMI port. (See Note 2).
8. Depress ENTER key. (See Note 4).
VMI INITIAL IZEl
MOD 1
S L OT 7 C H 2
9. Repeat steps 7 and 8 for all VMI ports to be assigned.
10. Depress the SPKR key to go back on line.
300-210