user manual

ND-20292
CHAPTER 3
APRIL, 1990
KEY FUNCTION (OFF LINE)
jPKR - ON/OFF Line
i?EL # - Enters new Trunk Group number
F/W - Increments Trunk Group number
CLEAR -
ENTER - Enters each assignment
B/W - Decrements Trunk Group number
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK BEING
MEMORY BLOCK THAT
MEMORY BLOCK THAT MAY
PROGRAMMED
MUST BE PROGRAMMED
HAVE TO BE PROGRAMMED
4El-4E5 2A10,2B10,2C1-2C3
4E6
ZCE,2E1,4E7-4ElO
I
I I
I
CPU-EB or higher (See NOTE 2)
NOTES:
1. After a trunk group has been selected, Ll -L8 and
L13-L16 will show the previous assignments.
L9-L12 may be lit and can be changed in status,
however, they perform no function at this time.
2. Timing Parameters:
LINE BUTONS
FUNCTION
Tandem Restriction / LCRCPU:EBZ
Control Timerrwr
L13 L14 l-15 L16 OutgoingGuard Time
L5 L6 L7
l-8 Timeout for
Ll L2 L3
Wink/Delay
L4 Signal Detectior
4 1
IN SECS.
IN SECS.
IN SECS.
1 I1 I1 9 1 14
1 28
._._._._._._.-._._._.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.
- 4
- 5
_ 6
C
6
:
3
Outgoin
10 secon %
Guard Time must be assigned less than
s.
Out oing Guard Timer can be used for Loop Dial
Tie lnes only.
E
E&M Tie Lines have a fixed outgoing Guard Time
of 20 msec.
See Section 350 for definitions and additional
information.
Depressing the ENTER key will automatically
return you to step 3.
I
GENERAL INFORMATION - TLI - Ill INITIALIZE VALUES
I
i
This area of the memory block is used to assign various timing parameters, listed above, to each Trunk Group
i associated with TLI-E( ) ETUS.
i
I
L.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.,
300 - 229