user manual

ND-20292
CHAPTER 3
APRIL, 1990
MEMORY BLOCK 4E7 - TLI-IV INITIALIZED VALUES
:-J
‘, ,;;’
1. Go off line. OF F - LINE (X-XX)
PROGRAM MODE
2. Depress F4, then FlO.
T L I
PROGRAMMI NC
3. Depress F17.
4. Dial CCU module number (1 - 4) where TLI port
being assigned is located.
Example: Module 1.
5. Dial CCU slot number (1 - 8) where TLI port is
being assigned. Example: Slot 5.
6.
Dial TLI channel number (1 - 2) of TLI port to be
assigned. Example: Channel 1.
T L I
I NI TI ALI ZE4
,M 0 D ?
SLOT* CH”
TLI
I NI TI ALI ZE4
MOD1 SLOT? CH”
.T L I
I NI TI ALI ZE4
I
MOD1
S L OT 5 C H ?
I
.T L I
I NI TI ALI ZE4
MOD1 S L OT 5
C H 1
7.
8.
9.
10.
Depress Ll to L16 to set the desired pad parameters (See Note 1). Corresponding LEDs go on or off
accordingly.
Depress ENTER key (See Note 2).
TLI
I NI TI ALI ZE4
-M 0 D 1
S L OT 5
C H 2
Repeat steps 4 thru 8 for all trunks associated with TLI-EB ETUs to be programmed, or depress TEL # to
program a specific TLI-EB port.
Depress the SPKR key to go back on line.
OPERATION - AND - DISPLAY
300 - 230