user manual

ND-20292
CHAPTER 3
APRIL, 1990
: I--:*
MEMORY BLOCK 4E8 - TLI-V INITIALIZED VALUES
-?
-9
OPERATION - AND - DISPLAY
1. Go off line.
2. Depress F4, then FlO.
3.
Depress F18.
4. Dial CCU module number (1 - 4) where the TLI
port to be programmed is located.
Example: Module 1.
5. Dial CCU slot number (1 - 8) where TLI port is to be T L I I NI TI ALI ZE5
programmed. Example: Slot 5.
MOD1
S L OT 5 CH?
6. Dial TLI channel number (1 - 2) of TLI port to be
TLI
I NI TI ALI ZE5
assigned.
Example: Channel 1.
MOD1
S L OT 5 C H 1
7.
8.
9.
IO.
Depress Ll to L12 to set the desired DTMF parameters of the selected TLI port (See Note 1).
Corresponding LED(s) go on or off accordingly.
Depress ENTER key. (See Note 2).
Repeat steps 4 thru 8 for all trunks associated with TLI-EB ETUs to be programmed.
Depress the SPKR key to go back on line.
OF F - LINE (X-XX)
PROGRAM MODE
T L I
PROGRAMMI NG
T L I
I NI TI ALI ZE5
MOD? SLOT* CH*
TLI I NI TI ALI ZE5
MOD1 SLOT? CH*
.T L I
I NI TI ALI ZE5
MOD1
S L OT 5 CH2
300 - 232