user manual

ND-20292
CHAPTER 3
APRIL, 1990
KEY FUNCTION (OFF LINE)
SPKR - ON/OFF Line
TEL#-
F/W -
CLEAR -
ENTER - Copy
B/W -
GUIDE TO FEATURE PROGRAMMING
I I
I.
dEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
‘ROGRAMMED MUST BE PROGRAMMED HAVE TO BE PROGRAMMED
All CPU levels.
NOTES:
1. The following memory blocks are the only
memory blocks that can be copied using this
feature:
1A
1B
lC3
lC4
1Dl
lD4
lD5
lD6
lD7
lD8
3c2
Line Key Assignment (copies all Line
Keys except Secondary Extension or
Primary Extension).
Ringing Assignment (Day & Night)
DSS Button Assignment
(Feature and Station Appearance)
Flexible Function Key Assignment
Prime/Ringing Line Assignment
Trunk Group Incoming Restriction
Trunk Group Outgoing Restriction
Code Restriction Table Access
Class of Service
Station to Attendant Assignment
Trunk name Assignment
2. All stations being copied should be the same type,
3. Depressing the ENTER key will cause the feature
assigned to the station identified in step 1 to be
copied to all stations between the lowest and
highest station (inclusive) defined.
4. After the ENTER key is depressed, the display
will return to the feature from step 1 with the
station number incremented by one.
GENERAL INFORMATION - STATION COPY ASSIGNMENT
I I
! This area of the memory block is used to copy the assignment of one station to as many stations as desired
; in one step. This greatly reduces programming time by allowing the repetitious assignments to be copied
i
;
[ instead of using the individual programming steps.
I
‘.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.
-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-,-.-.-,-.-.~
300 - 239