user manual

ND-20292
CHAPTER 1
APRIL, 1990
jack is provided by the telephone company. Jacks for
this type of customer provided equipment will not be
provided on party lines or coin lines.
The telephone company may make changes in its
technical operations and procedures. If such changes
affect the compatibility or use of this telephone system,
the telephone company is required to give adequate
notice of the changes.
120.2 COMPANY NOTIFICATION
Prior to the connection or disconnection of this
telephone system to or from the telephone network, the
telephone company must be provided with the
following:
1. Your telephone number.
2. FCC registration number:
a. When the Electra Mark11 is to be installed as a
multifunction system, the registration number
to be provided to the local telephone company
is:
AY54SM-19165MF-E
b. When the Electra Mark11 is to be installed as a
key system, the registration number to be
provided to the local telephone company is:
AY54SM-19166.KF-E
To install the Electra Mark11 as a key system, the
system cannot contain dial access to the Trunk Groups.
The Trunk Group to Access Code Group Assignment
must be programmed to make vacant all Access Code
Group Assignments, or SW3-1 on the CPU-EC4 (if
equipped) be in the ON position.
3. Ringer equivalence number: 2.OB
4. USOC Jack required: RJ2lX for fifty position
SECTION 130
amphenol type connector.
GLOSSARY OF ABBREVIATIONS
Items 2 and 3 mentioned above, are also indicated on
the system equipment label.
120.3
INCIDENCE OF HARM
System malfunctions may also cause harm to the
telephone network. The telephone system should be
disconnected until the source of the problem can be
determined and until repair has been made. If this is
not done, the telephone company may temporarily
disconnect service.
120.4 EMITTED RADIO FREQUENCY
INTERFERENCE
In compliance with FCC Part 15 rules, the following
statement is provided:
IMPORTANT NOTE
“This equipment generates, uses, and can radiate
radio frequency energy and if not installed and
used in accordance with the installation service
manual, may cause interference to radio
communications. This equipment has been tested
and approved for compliance with the limits for a
Class A computing device pursuant to Subpart J of
Part 15 of FCC Rules, which are designed to
provide reasonable protection against such
interference when operated in a commercial
environment. Operation of this telephone system in
a residential area, is likely to cause interference, in
which case the user, at his or her own expense, will
be required to take whatever measures may be
required to correct the interference.”
120.5
HEARING AID COMPATIBILITY
The NEC Telephones provided for this system are
hearing aid compatible. The manufacturer of other
single line telephones must provide notice of hearing
aid compatibility to comply with FCC rules. FCC rules
prohibit the manufacture of non-hearing aid
compatible telephones (after August 16,1989).
120.6 SERVICE REQUIREMENTS
In the event of equipment malfunction, all repairs are
to be performed by an authorized agent of NEC
America, Inc. or by NEC America, Inc. It is the
responsibility of users requiring service to report the
need for service to an authorized agent of NEC
America, Inc. or to NEC America, Inc.
ADA
ANA
ANS
ATT
-A-
Ancillary Device Adaptor
Assigned Night Answer
Answer Key
Attendant
BGM
BLF
-B-
Background Music
Busy Lamp Field
CCSA
-C-
Common Control Switching
Arrangement
100-2