user manual

ND-20292
-CHAPTER 4
APRIL, 1990
0
l
NOTE 1:
NOTE 2:
SAMPLE LED INDICATIONS
Dial internal extension or trunk access
code followed by telephone number to be
stored.
, I
Depress CNF key.
CNF LED goes off.
When system speed dial number needs
to be entered into speed dial buffer, enter
a trunk access code, depress ANS key in
place of dialing #, and then enter system
speed dial buffer number (20-99) . If a
pause is required anywhere in the
dialing of the number, depress the TRF
key (Each depression counts as one of
the 16 digits).
Hookflash (RECALL key) signal can be
registered as the first digit of a Speed
Dial number at a Multiline Terminal
with an LCD only. The CO/PBX line
must be programmed as PBX. A
Hookflash counts as 1 digit.
b. To Verify (Only from Multiline Terminal
with LCD):
b. 1 Using DSS key:
l
Depress desired DSS key to be verified.
l Check contents of the buffer on the LCD.
(The LCD automatically returns to
normal mode in about 10 seconds.)
SAMPLE LCD INDICATIONS
SIPIDI I I ITIRIKI Mcbl I I
6~1~6~7b~3~7~0~0~0~ I I I I I
I I I I I I I I I I I I I I I
Ilo1 :I4151 IoIcITI I2181 1~1~11
I I I I II I I I I I I I I I
1101 :I4151 101~1~1 I2181 IFIRII
400-67