user manual

ND-20292

CHAPTERS

APRIL,1990

NOTE: Consecutive dialing cannot be made in the following cases:

Station or system speed dialing sequence follows a manual

dialing sequence.

Station or system speed dialing sequence follows another speed

dialing sequence.

b. Using the FLASH key (or momentarily depressing the hookswitch):

Depress the FLASH key and receive second dial tone.

Dial the CO release access code. CO/PBX/Tie line/DID call is

released and new internal dial tone is provided.

2. Answering:

Lift handset and converse.

Dial the Hookflash to CO access code and new outside dial tone

is received.

5. Sending a Hookflash to the CO/PBX Line:

Placing A Call On Hold:

With call in progress:

Depress the FLASH key (or momentarily depress the

hookswitch) and receive second dial tone.

Dial access code (Default: 4 #) to place call on exclusive hold

and hang up.

Lift handset to place another call or to retrieve the held party

by dialing access code (Default: 4 #).

4. Abandoning a Call

Depress the FLASH key (or momentarily depress the

hookswitch) and receive second dial tone.

0 Dial the Hookflash to CO access code.

NOTE: CO Release access code and Hookflash to CO access code must

be assigned to the system before these features can be used.

This feature will operate only when the trunk is programmed

as a PBX line.

a. Using the handset:

Restore handset.

400

143