user manual

ND-20292
CHAPTER 2
APRIL, 1990
I
I
Figure 200-27
Mounting the RS-232C Connector
removed or inserted without powering down the
ecu.
Switch DIP1 (see Figure 200-30 and Figure 200-
31) is a 7 position dip switch which is used to
select baud rates in the range of 150 - 9600 (4800
is the recommended setting).
LED1 (Green) lit, indicates that the LCI+E ETU is
receiving power.
2. Connection of LCR
A. The LCR-E ETU must be installed into either
OPT1 or OPT2 or any combination slot of any
CCU. Prior to installation, ensure that
switch SW1 is set to the ON position and that
the baud rate switch DIP1 is set to the proper
position.
When installing the LCR-E ETU, turn SW2 OFF for
insertion of this ETU into the slot without powering
down the CCU.
Month, Day, Year (8 characters1
Hour, Minute, AM or PM (7 characters)
Type of Call: OG, IC, OT, IT,OGC,ICC, OTC, ITC (2 or 3 characters)
Station Number (3 or 4 characters)
“i” 00:1,5:32 1028;51~537000
Least Cost Routing (LCR) without account code
Number Dialed: Manually or Speed Dial (Max. 24 characters)
Call Duration: Hour, Minute, Second (8 characters)
Least Cost Routing (LCR) with account code
Forced Account Code (Max. 14 characters). See Note 3.
NOTE 1: A maximum of 34 characters can be printed per line.
NOTE 2:
Types of calls are as follows:
OG: Outgoing Call
IC: Incoming Call
OT: Transferred Outgoing Call
IT: Transferred Incoming Call
OGC:
Conference on Outgoing Call
ICC:
Conference on Incoming Call
OTC: Conference on Transferred
Outgoing Call
ITC: Conference on Transferred
Incomin Call
NOTE 3: An ‘“A” prior to the Account Code, is printed only when the Forced/Ver’ led function is provided in
d
‘,-
the system.
p
Figure 200-28 SMDR General Format of Call Records
200-30