user manual

NEC AMERICA, INC.
BUSINES’S SYSTEMS DIVISION
ET1 NUMBER: MK-005
DATE: OCTOBER, 1987
DASA D-4800 DIRECTORY DIALER CONNECTION
1.
DESCRIPTION
This Engineering Technical Information (ETI) Bulletin describes the steps necessary to install an ADA-E
(Ancillary Device Adaptor1 into an ETE-GD-1, ETE-16D-1, ETE-IGK-1, or ETE-6-1 Multiline Terminal, for
the connection and operation of a DASA Directory Dialer (Model D-4800). It also provides the information
required to connect the DASA Directory Dialer to the ADA-E unit and to get it ready for programming.
2. LIMITATIONS
2.1
2.2
You must depress the CLEAR button on the D-4800 dialer, after a connection to a CO line is
established and station goes off hook, to release the dialer from the line.
The dialer cannot be used for internal calls or for any system feature function requiring a dial access
code.
3.
PARTS REQUIRED
3.1 ADA-E Adaptor kit. (Stock #700340)
3.2 DASA D-4800 Directory Dialer.
3.3 RJ-35X modular jack.
3.4 Approximately 6 feet of four conductor station wire; to reach from the Multiline Terminal to the
RI-35x.
3.5 Four small spade lug terminals (to fit wires in step 3.4).
3.6 Electra Mark11 Multiline Terminal.
4. PROCEDURE
4.1 Disconnect the modular handset cord from the lower housing.
4.2 Disconnect the modular line cord from under the terminal and from the E&J-13C!/W jack.
4.3 Turn the Multiline Terminal upside down (face down) and place it on a flat surface (refer to Figure 1).
4.4 Slide the directory out of the way (Not required for ETE-6-1 Multiline Terminal).
1 of 6