user manual

3.6 Locate the four pin connector and jack labeled HAND (as seen through the access view of the Multiline

Terminal housing). Unplug this connector and extend it out from the housing access opening.

3.7 On the ADA-E Unit, set the Dip switches (SW21 as shown in Table 1 (See Figure 2). Place the jumper

across the center pin and the pin labeled ST2; set switch SW1 to the BREAK position.

3.6 Make the handset amplifier connections as indicated in Figure 2. Insulate connections with the tubing

provided, if necessary.

NOTE: The green lead provided in the Melco-Sll amplifier wire harness has a female connector that

cannot be connected directly to the T-11 terminal.

Use one of the double ended spade lug short jumper

wires provided in the ADA-E kit and connect one end of the jumper wire to the female connector of the

green lead and the other end to the T-l 1 terminal. Use tape to insulate the connection.

3.9 Locate and insert the four pin connector ended harness from the ADA-E unit into the jack labeled

HAND on the Multiline Terminal.

3.10 Locate and insert the eight pin connector ended harness from the ADA-E unit into the jack labeled

ADA on the Multiline Terminal.

3.11 Insert the four pin connector ended harness (removed in step 3.6) into the four pin jack, CN3, located on

the ADA-E unit.

3.12 Install the ADA-E unit with the component side down ensuring the wires are not pinched. Secure the

ADA-E unit to the terminal housing with the screw provided as shown in Figure 3.

NOTE: Two Access Cover Panels are provided with the ADA-E Unit, the narrower panel is for the

ETE-6-1 Multiline Terminal, the wider panel is for all other Multiline Terminals.

3.13 Place the handset amplifier wiring into the cable exit groove (Figure 3) making certain that all wires

are inside the housing. Install the correct access cover assembly.

NOTE: The handset amplifier may be mounted to the side of the Multiline Terminal with double sided

foam tape or any other secure method of your own choosing.

3.14 Reinstall the handset and modular line cords.

3.15 If slid out of the way in step 3.4, slide the directory back into place.

3.16 Adjust the amplifier volume control and test the Multiline Terminal and amplifier for proper

operation.

2 of 5