user manual

7.2
7.3
ET1 NUMBER: MK-019
DATE: MAY, 1988
7.1.5
After all parties are connected and on hoid (except the last number which was dialed), wait
5
seconds and dial 3 to establish the conference.
NOTE: After dialing 3 and establishing a conference, dialing 1 provides the initiator with
dial tone while the parties in the conference can continue their conversation.
Establishing a remotely initiated conference.
NOTE: To access the CONFER@ unit from a remote location, the CONFER@ unit must be
programmed for remote access mode and an authorization code (four digit code) must already be
programmed (See step 6.1).
7.2.1 Call the control line number assigned to the CONFER@ unit.
7.2.2
Once the CCNFERa unit answers (after approximately 4 rings) and confirmation tone is
returned, dial the 4-digit remote access authorization code after the confirmation tone
stops.
7.2.3
When dial tone is heard, dial the telephone number of the first party to be conferenced. When
the first party answers, inform the party that you are initiating a conference and then dial
1.
(Dialing 1 puts the party on hold and new dial tone is received).
7.2.4
Repeat step 7.2.3 until you have called all the parties to be involved in the conference
(maximum of five including the originator). If a mistake is made in dialing, or if the number
dialed is busy, dial 2 to disconnect the last number called.
7.2.5
After all parties are connected and on hold (except the last number which was dialed), dial
3
to establish the conference.
NOTE: After dialing 3 and establishing a conference, dialing 1 provides the initiator with
dial tone while the conference continues.
Terminating or leaving a conference.
7.3.1
Any party that wishes to leave the conference hangs up; remaining parties continue
conferencing.
7.3.2
The initiator of the conference hangs up or dials # to terminate the conference.
8. PROCEDUKE
LAST 5
ELECTRA
CO LINES
5 5
MARK11 4 4
SYSTEM 3 3
2 2
CONTROL LINE 1 1
REMOTE
CONFER
ACCESS PORT
Figure 1. Typical Installation
i
C
0
L
I
N
E
5
8.1 Refer to Figure 1 for an overview of a typical installation.
3
of
5