user manual

8.2
a.3
8.4.
8.5
Loosen four screws (2 on top, 2 on the bottom) and remove the CONFER@ unit cover.
. .
i
Position the CONFER@ unit against a vertical surface. Make sure that the arrow on the power unit’s
shield is pointing up (See Figure 2).
Using the CONFER@ unit as a template, mark and drill four holes on the vertical surface and fasten
the CONFER@ unit to a wall using wood screws or wall anchors.
Connect the 36-pin male connector to the CONFER@ unit (See Figure 2).
P%x:R
8.6
8.7
8.8
8.9
8.10
8.11
9
8
n
UP
RED
yP?FiiFR
36-PIN
CONNECTOR
/
CABLE
BRACKET
/
)$-TO: MDF
RESET
BUTTON
-------(BOTTOM PCB)
.I
Figure 2. CONFER,3 Unit with cover removed.
Locate the last five CO line pairs on the 66 block and remove the bridging clips
Connect the open end of the 36 pin connector cable to the 66 block, on the KSU side, as shown in
Figure 3. Any spare wires should be insulated and tied back.
Ground the CONFER@ housing to an available ground connection as described in the CONFER’3
Installation Manual.
Plug the CONFER@ unit into the AC outlet and observe that the red power LED on the upper corner of
the CONFER@ unit lights.
Depress the reset button located at the lower right hand corner of the CONFER@ board (See Figure 2).
Refer to the installation manual and match each CO line to the CONFER@ unit as described.
4of 5