user manual

ND-20292
CHAPTER 2
APRIL, 1990
Table 200-18 Ancillary Device,
dultiline Terminal Compatibility
ANCILLARY
I I
DEVICES
ETE-6( 1 ETE-GD-( )
ETE-16-2 1 ETE-16D-( ) 1 ETE-16K-1
.
HFU-E ETU
0 8 8 0 0
DPA-E ETU
0 8 8 0 0
ADA-E ETU
0 0
0 0 0 0 0 0
DTA-E ETU
0
0 0 0 0
l = Compatible
These optional devices are installed inside the
access panel on the bottom of Multiline
Terminals. A maximum of one unit of each type
can be installed in each Multiline Terminal,
except for ETE-8( ) or the ETE-16-2, which can
only accept the ADA-E Unit. The DTA-E Unit
comes with a special access panel to allow its
installation into the Multiline Terminals.
WARNING
C.
G. Secure the HFU-E Unit by inserting the screw
provided with the Unit.
H. Replace the access panel
OR
continue to install the DPA-E Unit, DTA-E Unit,
or ADA-E Unit.
260.3 DUAL PATH ADAPTOR UNIT (DPA-E)
Prior to installing any optional device, unplug the
line cord from the Multiline Terminal and the
RJlSC/W. Failure to do so could result iu damage
to the optional ancillary devices.
NOTE: For installation in all Multiline Terminals
except the ETE-6-t ) or the ETE-16-2.
,I
260.2. HANDSFREE UNIT (HFU-E)
NOTE: For installation in all Multiline Terminals
except the ETE-6-( I or the ETE-16-2.
Unplug the line cord at the RJ13CYW and the
terminal, then turn the Multiline Terminal
upside down (face down) and locate the access
panel on the bottom of the Multiline Terminal.
Refer to Figure 200-41.
Slide the directory out of the way.
Insert a flat screwdriver blade into the notched
opening (shown as A) and apply light upward
pressure until the access panel is cleared of the
front lip, at the same time apply pressure
(towards you) at the rear of the pedestal (shown
as B) until the access panel moves towards you.
Remove the access panel and place it aside for
later reinstallation.
Locate the fourteen pin jack labeled HFU-E, as
seen through the access view of the housing,
insert the fourteen pin connector from the HFU-E
Unit, as shown in Figure 200-42.
Place the HFU-E Unit into its designated area,
with the cable side down.
A.
B.
C.
D.
E.
.: F.
Figure 200-41 J(u~~~a;e Terminal Access Panel
A. Unplug the line cord at the RJ13C/W and the
terminal, then turn the Multiline Terminal
upside down (face down) and locate the access
200 - 35