user manual

ETI NUMBER: MK-017
NOTE 4:
in-house Fax machines may require a minimum time (number of rings) before a Fax to Fax connection can
be made.
4. REFERENCES
Viking Technical Practice notes (included with product).
Viking Electronics, inc.
1531 Industrial Street
Hudson, WI 54016
Sales: [phone]
5. SITE REQUIREMENTS
. .
Both products must be mounted near a 120V AC source. Site location is limited only by the location of the COI-
E/EB ETU port jack and the additional devices.
6. PROCEDURE
6.1 For connection of the Viking Fax Jack III. See Figure 1.
6.1.1
6.1.2
6.1.3
6.1.4
6.1.5
NOTE:
6.1.6
Determine the location for mounting the Viking Fax Jack III. Ensure that the desiqnated COI-E/EB ETU
port iack and 120V AC power source are nearbv.
Install the COI-E/EB ETU in an available interface slot (if an COI port is not available).
Insert the RJl 1 connector from the Fax Jack III to an incoming CO line port jack.
Using a modular line cord with RJl 1 connectors, connect a COI-E/EB ETU to the Phone Connector on
the Fax Jack Ill.
Using another modular line cord with RJI 1 connectors, connect the data port on the Fax Jack RI to
either a fax machine, modem, or other data transmission device.
Switch 1 (located on the rear of the Fax Jack III) determines whether a fax machine or a modem will be
connected to the data port.
Plug the AC adaptor into the Fax Jack III and the 12OV AC power source.
Refer to the Technical
Practice notes for proper switch setting.
6.2 Electra Mark II Programming
6.2.1 No special programming is required for the Electra Markll. When installing the COI-E/EB ETU, a trunk
number is automatically assigned for the port representing the Fax Jack III.
6.2.2 Refer to the Viking Technical Practice notes for programming the Fax Jack III to your particular
application.
6.2.3 Test the Viking Fax Jack III for proper opration with the Electra Markll.
6.3 For connection of the Viking PathFinder see Figure 2.
2OF5