user manual

ND-20292
CHAPTER 2
APRIL, 1990
Figure 200-44
Connection of DTE/DTA-E Unit
Remove the access panel, save for possible future
use.
D.
Before installing the DTA-E Unit, its switches
should be set for the proper assignment. (Refer to
Table 200-19).
The DTA-E Unit contains a 7 position DIP switch
designated SW1 a slide switch designated SW2, and an
8 position DIP switch designated SW3.
Table 200-19 shows the assignments of these switches.
E.
After assigning the switches, locate the fifteen
pin connector labeled DTE, as seen through the
access view of the Multiline Terminal housing,
insert the ftiteen pin connector from the DTA-E
Unit, as shown in Figure 200-45.
F.
Replace the access panel.
OR
Continue to install the ADA-E Unit, DPA-E Unit,
or HFU-E Unit.
Figure 200-45 DTA-E Unit
200 - 38