user manual

NECAmerica Inc. Switchin Terminals Division
c
ELECTRA MARK11 ETI NUMBER: MK-018 DATE: APRIL, 1990
1. DESCRIPTION
This Engineering Technical Information (ETI) Bulletin describes the procedure for connecting the Soft-Corn Scout
Jr. Call Accounting System to the Electra Markll system via the SMDR-E ETU. This Call Accounting System consists
only of software that must be stored on a personal computer hard disk.
NOTE:
Before undertaking this procedure, the installer should be familiar with the Soft-Corn Scout Jr. Technical
reference manual and Chapter 2 of the Electra Markll Installation Service Manual.
2. PARTS REQUIRED
2.1 SMDR-E ETU.
2.2
Soft-Corn Scout Jr. (Version 4.3 or higher) Call Accounting System. This system can support a maximum of
eighty (80) extension numbers.
Soft-Corn Inc.
140 West 22nd Street
New York, NY 10011
[phone]
2.3 RS-232C Straight Cable with male connectors at both ends.
2.4 An NEC Powermate or IBM compatible computer with hard disk. The following are the basic requirements:
l 640K RAM
l Communications Port
l Hard Disk - 20 Mbytes Minimum
) 5 Mbytes for storing the Scout Jr. resident program.
) 10 Mbytes allows 10,000 calls to be stored.
l One 5-l/4” or 3-l/2” Floppy Disk Drive
l Display/Printer Interface Card
l Monitor
l MS-DOS Version 3.1 or higher
(Refer to the Scout Jr. manual for additional computer hardware requirements).
2.5
Serial or parallel printer (to be used for the printing of call record reports). This printer must be connected to
the computer.
3.
OPERATION
After installation and programming are completed, system managers of the Scout Jr. system will be able to print call
record reports showing incoming and outgoing calls by extensions, departments, trunks, account codes, etc. In
addition, the Scout Jr. allows custom reports to be printed for programmable variables.
1 OF3