user manual

CONNECTION OF A PANASONIC AUTODIALER
TO A Dterm II (ETE-1-2)
Dterm II
ETI NUMBER: DS-007
DATE: APRIL, 1990
2.
3.
6.
DESCRIPTION
This Engineering Technical information (ETI) Bulletin provides installation instructions for connecting a
Panasonic Autodialer to a Dterm II telephone (ETE-l-2).
LIMITATIONS
2.1 Autodialer should be turned off after the call is established.
PARTS REQUIRED
3.1 Dterm II (ETE-l-2).
3.2 Panasonic Autodialer (model KX-T1235D)
Autodialer is available at any local Panasonic sales office.
3.3 RJ-35X Modular jack
3.4 Needlenose pliers.
3.5 Four pieces of 24 AWG wire (minimum length:
6” each)
3.6 Four small spade lugs.
REFERENCES
4.1 Panasonic Autodialer installation Guide.
4.2 Dterm II (ETE-l-2) Users Guide.
OPERATION
5.1
5.2
5.3
5.4
5.5
Depress the ON/OFF button on the Autodialer to the ON position.
If using the Speed Dial button, set the Dialing Selector to Auto mode on the autodialer. If using the dial
pad on the Autodialer, switch the Dialing Selector to manual mode.
Depress the desired Speed dial button or use the dial pad to place a call.
Monitor the call through the speaker of the Autodialer.
When the called party answers, lift the handset, depress the ON/OFF button on the Autodialer to OFF and
converse.
PROCEDURE
6.1 Disconnect the line and handset cord from the Dterm telephone.
6.2 Place the Dterm II upside down on a clean, flat work surface.
6.3 Slide the Directory out and place it aside.
1 OF5