user manual

NEC America, Inc.
Switching Terminals Division
-‘K& .
-
‘“‘///////////////////////////////////// INFORMATION
DtermSERlES II
ET1 NUMBER: DT-002
DATE: DECEMBER 1988
PANASONIC AUTODIALER CONNECTION
1. DESCRIPTION
This Engineering Technical Information (ETI) Bulletin describes the steps necessary to install an ADA-E (Ancillary
Device Adapter) unit into an ETE-6D-2, ETE-16D-2, ETE-16-2, or ETE-6-2 Multiline Terminal, to provide for connection
and operation of a Panasonic Autodialer (Models KX-T1225/KX-T1235).
2.
LIMITATIONS
2.1
The dialer must be manually turned OFF after the call is established.
2.2
The dialer cannot be used for intercom calls or for most functions requiring an access code
2.3 The dialer bypasses both Toll Restriction and LCR.
2.4 The digits dialed, from the dialer, will not appear on the SMDR printout.
3. PARTS REQUIRED
3.1
ADA-E Unit Adapter Kit (Stock # 560280).
3.2 Panasonic Autodialer (KX-T1225/KX-T1235).
3.3 R&35X modular jack.
3.4
Eight small spade lugs.
3.5 Approximately 7 feet of four conductor station wire cable: enough to reach from the Multiline Terminal to the R.J-
35x.
3.6
Dterm Series II Multiline Terminal.
1 of 6