user manual

ETI NUMBER: DT-005
5.9 Connect one end of the two conductor wire to the screw terminals on the provided power supply.
Connect the other end of the two conductor wire to the (BROWN/WHITE and WHITE/BROWN) of the
Companion II Speakerphone (See Figure 2).
5.10 Using the connecting cable from the Speakerphone, make the wiring connections shown in Figure 2.
If necessary, use a section of the clear plastic tubing provided in the ADA-E kit to insulate the
connections. Individually insulate the unused leads.
5.11 Locate and insert the four pin connector ended harness from the ADA-E unit into the jack labeled
HAND on the Multiline Terminal.
5.12 Locate and insert the eight pin connector ended harness from the ADA-E unit into the jack labeled
ADA on the Multiline Terminal.
5.13 Insert the four pin connector ended harness (removed in step 5.6) into the four pin jack, CN3, located
on the ADA-E unit.
5.14 Install the ADA-E unit with the component side down ensuring the wires are not pinched. Secure the
ADA-E unit to the terminal housing with the screw provided as shown in Figure 3a. (ETE-6D-0, ETE-
160-0, or ETE-16K-1) or 3b (ETE-6-0, or ETE-16-O).
NOTE 3
Two access panels are provided with the ADA-E unit; a narrow
panel to be used with ETE-6-O or ETE-16-O Multiline Terminals
and a wide panel to be used with all other terminals. Ensure the
correct access panel is used.
5.15 Route the Speakerphone wires (already connected to the ADA-E unit) through one of the two
notched grooves on the access panel. Install the access panel.
5.16 Slide the Multiline Terminal directory back into place, if required.
5.17 Reinstall the handset line cord onto the Multiline Terminal.
5.18 Plug the AC adaptor to the Speakerphone first, then plug it into a convenient AC outlet.
5.19 Refer to the Speakerphone’s user guide and test both the Speakerphone and the Multiline Terminal
for proper operation.
3 of 7