user manual

G Dterm SERIES II TERMINALS and ELECTRA
MARK II TO DICTAPHONE VOICE RECORDER via
ADA-ER UNIT
ETI NUMBER: DT-007
DATE: JUNE 1989
1. DESCRlPTlON
This Engineering Technical information (ETI) Bulletin describes the steps necessary to install an ADA-ER
(Ancillary Device Adaptor) into an ETE-6D-0, ETE-16D-0, ETE-16-0, ETE-6-0, or ETE-16K-1 Multiline
Terminal, for the connection and operation of a Dictaphone Veritraco 5000/9000 voice recorder.
2. LlMlTATlONS
2.1 The Multiline Terminals do not need any control over the DICTAPHONE voice recorder.
CAUTION
THE USE OF A MONITORING DEVICE TO EAVESDROP OR RECORD
TELEPHONE CONVERSATIONS MAY CONSTITUTE AN ILLEGAL INVASION
OF PRIVACY UNDER SOME CIRCUMSTANCES AND LAWS. YOU SHOULD
CONSULT A LEGAL ADVISOR PRIOR TO IMPLEMENTING ANY PRACTICE
INVOLVING RECORDING OF TELEPHONE CALLS.
FCC ORDER IN DOCKET #209$0 PERMITS THE USE OF BEEP TONE -OR- THE
CONSENT OF ALL PARTIES WHEN CONVERSATIONS ARE RECORDED.
SECTIONS 2510 TO 2520 OF THE U.S. CRIMINAL CODE (18U.S.C.2510 et
seq.) PROVIDES STIFF PENALTIES FOR UNAUTHORIZED DISCLOSURE OF
WIRE OR ORAL COMMUNICATIONS.
3. PARTS REQUIRED
3.1 ADA-ER Unit (Stock #560281).
3.2 A Dictaphone VeritracQ Series 5000/9000 voice recorder.
3.3 #24AWG two conductor stranded cable.
3.4 Two small spade lug terminals to fit wires in step 3.3 (locally provided)
4. PROCEDURE
4.1 Turn the Multiline Terminal upside down (face down) and locate the access panel on the bottom of
the Multiline Terminal, refer to Figure 1.
4.2 Disconnect the modular line cord from under the telephone at the RJ-1 lC/W jack.
4.3 Disconnect the modular handset cord from the lower housing.
4.4 Slide the directory out of the way (Not required for ETE-6-O or ETE-16-O Multiline Terminal).
1 OF7