user manual

ETI NUMBER: MK-017
6.3.1
Determine the location for mounting the Viking PathFinder. Ensure that the desiqnated COI-E/EB
ETU port iack and 12OV AC power source are nearbv.
6.3.2
6.3.3
Install the COWEB ETU in an available interface slot (if a COI port is not already available).
Insert a modular line cord with RJll connectors from the Telco connector of the PathFinder to
incoming CO line portjack.
6.3.4
Using a modular line cord with RJl 1 connectors, connect a COI-E/EB ETU to the phone connector on
the PathFinder.
6.3.5 Using other modular line cords with RJl 1 connectors, connect a fax machine to the fax connector on
the PathFinder and a modem to the modem connector on the PathFinder.
NOTE:
These port can be used to connect other fax machines, modems, or data transmission devices.
6.3.6
Plug the AC adaptor from the PathFinder to the 12OV AC power source.
6.4
Electra Markll Programming
6.4.1 No special programming is required for the Electra Markll. Upon installation of the COI-E/EB ETU, a
trunk number is automatically assigned for the port representing the PathFinder.
6.4.2
Refer to the Viking Technical Practice notes for programming the PathFinder to your particular
application.
6.4.3 Test the Viking PathFinder for proper operation with the Electra Markll.
3OF5