user manual

ETI NUMBER: DS-005
5.4 Activate RECORD mode and converse with called party.
5.5 Upon completion of the call, place the handset on-hook and stop RECORD.
5.6 Remove the remote plug from the jack, rewind the tape and playback the recording.
5.7 Reconnect the remote plug for recording of the next call.
6.
PROCEDURE
6.1
6.2
6.3
6.4
6.5
6.6
6.7
6.8
6.9
Disconnect the line and handset cord from the Dterm telephone.
Place the Dterm II upside down on a clean, flat work surface.
Slide the Directory out and place it aside.
Remove the access panel by-applying pressure (at the notch of the panel) and slide the access panel out as
shown in Figure 1.
.
ut the Access Panel
Dterm II Telephone
Figure 1. Access Panel Removal
Unscrew the two captive screws from the bottom of the housing. Separate the upper and bottom housings
as shown in Figure 2.
Route the #22 AWG four conductor stranded cable from the tape recorder through the access panel
window.
Make the wire connection to the spade lug connectors on the PCB. Refer to Table - 1 and Figure 3 for these
connections
Place the upper and bottom housings together, secure with the two captive screws that were removed in
step 6.5.
Following the pre molded guides inside the access panel cover assembly, route the Remote and MIC cables
through this notch. Refer to Figure 4.
2OF5