user manual

ND-20292
CHAPTER 7
APRIL, 1990
750.5.2 Warm Start
The Warm Start is performed by turning the power
switch ON. This is the normal method used that
allows retention of the LCR Main Menu program in the
computer. Under normal conditions, the last screen
displayed when power was turned off is returned when
power is turned back on.
750.5.3 Auto Start Setting
The PC-8300 has an auto start feature which allows
the computer to automatically load the LCR Main
Menu program from the disk drive unit when the reset
switch is used. The following procedure describes the
setting of the auto start feature to automatically load
the LCR Main Menu program. See Fitire 700-27 Rear
Side View of the PC-8300.
1. With the PC-8300 main menu displayed, depress
the f*l key. Display shows:
1983/05/O 1
14:22:13 (C) Microsoft #l
~ TU<T TELCOM _ _ _
-.-
-.- -.- -.-
-.-
-.- -.- -.-
-.-
-.- -.- -.-
-.-
-.- -.- -.-
-.-
-.- -.- -.7
Load from
2. The computer is prompting for a file name to be
loaded. The file name desired is IPL.DO. Since the
file is in the disk, it is necessary to enter 1: prior to
the file name. At this time use the keyboard
-This switch preveds data from
being entered into bank #2 if the
memoryhasbeeneqmdedto
in@& e$ra banks. The data within
thtsdhts~tsGth&n proleded from
TheRESEfswitchisusedto
peerform a ‘co!d start’. or as part d
a process to free the computer
when -hung up-. This switch should
onlybeusedasalastresort.since
tha~contenls of the memory of the
PC-8300 may be erased.
CMT port’
Canoed a dala recorder to lhe
PC-8300 here using the PCX493A
data redorder conneUioi7 cable
(induded in the PC-8300 box).
- PRINTER wrt’
4 FDO port-
Connect the Micro Disk Unil
(PG8231A ) here using lhe
modular jack cable (induded in the
PC-8231 A lxx).
* A proleclive cap has been fitted
on lhese connectors. Before
connecling a peripheral, remove
L
the cap. save il. and pun il back
over lhe connector v&en Ihe
peripheral is disconnecled.
ConneU’a~f&r Code Reader to lhe
PC-8300 here.
- PHONE port’
With the branched Phone Cable
(kxktded in the optional Modem
Card box). the PC-8300 is
connected to your telephone
system.
conned parailel centronics intedace
printers to lhe PC-8300 here wilh
the PCJM94A parallel printer cabte.
- RS-232C porl’
Conned a serial printer, an external
modem or a cable lo dfrectly
cOnned IO anolher computer here.
- BCRwrt’
Figure 700-27 Rear Side View of the PC-8300
700 - 18