user manual

ND-20292
CHAPTER 7
APRIL, 1990
3.
If a problem occurs during DOWN LOAD, UP
LOAD, or VERIFY an error is displayed, as
shown at right. Using the CR clears the
display and returns it to the preceding menu.
Whenever MODIFY, DISPLAY, or PRINT
OUT is used, the carriage return is depressed
after making the entries for selection of
desired data.
During MODIFY mode, CR (RETURN) is used
to enter the selected data entries for a
particular programming segment.
During DISPLAY or PRINT OUT mode, CR
(RETURN) is used to request disnlav of
additional data (in consecutive numerical
order).
ESC - Escape Key
The ESC key is used to return to previous menu
display any time a menu is displayed on the
screen. Also, the ESC key is used in the MODIFY
mode after completing the selection and/or entry of
desired data.
0 Example of ESC key being used to go from the
DISPLAY menu to the LCR main menu.
a Depress ESC key. Display shows:
0 During MODIFY mode, use of the ESC key
causes data to be saved to the disk drive and
then returns the display to the MODIFY
menu, as shown at right.
SAMPLE LCD INDICATIONS
AREA CODE TABLE DOWN LOAD START
ABNORMAL END
LINE TROUBLE
d-J
*** AREA CODE TABLE MODIFY***
TENANT NO. 11
***ARE$CO,DE TABLE DISPLAY***
TENANT NO.
AREA CODE j 200
;;kIkE 1;“”
:
: ZEEKLY
***DOWN LOAD***
AREA CODE TABLE 6 EXTRA CODE TABLE
2 WEEKLY SCHEDULE 7 OFFICE CODE TABLE
3 DAILY SCHEDULE
4 ROUTE ADVANCE t HoME NPA CoDE
5 ROUTE TABLE 10 ALL DATA
ENTER MENU NO.
***LCR MAIN MENU***
1 DOWN LOAD6 PRINT OUT
s &l??D
7 SYSTEM DATA CLEAR
8
4 MODIFY
5 DISPLAY
1: SYSTEM CONTROL
ENTER MENU NO.
SYSTEM DATA SAVING
I
***MODIFY***
1 AREA CODE TABLE
6 EXTRA CODE TABLE
2 WEEKLY SCHEDULER
7 OFFICE CODE TABLE
3 DAILY SCHEDULER
8 HOME NPA CODE
4 ROUTE ADVANCE
5 ROUTE TABLE
ENTER MENU NO.
700-22