user manual

ND-20292
CHAPTER 7
APRIL, 1990
Shown is the use of CR (RETURN) to increment the
item number.
l With Area Code Table Modify in the display (as
shown at right):
l Depress CR (RETURN) key.
l Depress CR (RETURN) again to display the
contents (see Notes below).
l To return to the previous menu, depress the ESC
key.
NOTE 1: After the first carriage return, the cursor is
positioned at the new item number line. At
this time a different item number may be
chosen. If this is done before the carriage
return, the data contents of the chosen item
number will be displayed. This option
applies to modify mode only.
NOTE2: The first CR (RETURN) increments the
item number. The second CR (RETURN)
displays the data for the item number.
750.9 EXPLANATION OF LCR COMMANDS
This section explains the LCR (RETURN) support
terminal commands required to properly program the
required data for operation of the LCR-E ETU.
It is
recommended that section 750.7 be fully read and
understood before reading this section.
SAMPLE LCD INDICATIONS
***AREA CODE TABLE MODIFY***
TENANT NO. 7 1
AREACODE 7 200
TABLE NAME : WEEKLY
TABLE NO. : 01
***AREA CODE TABLE MODIFY***
TENANTNO. 7 1
AREACODE ? ml
***AREA CODE TABLE MODIFY***
TENANTNO. 1 1
AREACODE ? 201
;;IWE ;$ME: q *****
- **
. .
After the initialization procedure has been completed,
powering up the programming computer results in
display of the LCR Main Menu, (See section 750.5 for
the initialization procedure if this has not been
completed.) The LCR Main Menu provides the
programmer with eight options.
700 - 33