user manual

ND-20292
CHAPTER 7
APRIL, 1990
1. Down Load Mode
l Selection of down load mode results in the
menu display at right.
At this time selection of one of the available table
numbers will result in the following display.
a Example for area code down load: Depress 1,
then depress CR (RETURN).
NOTE 1:
NOTE 2:
NOTE 3:
NOTE 4:
NOTE 5:
The display shown is an example of area
code data being down loaded from the floppy
disk into the LCR-E. The name of the table
chosen will be shown in the display.
Exceptions to note 1, are the office code
table and all data down load selections.
These two selections, due to their large
memory requirements show darkened boxes
to indicate the relative amount of data that
has been transferred.
If no problem is encountered during down
load, the display shown (or one similar to it)
is provided. Depression of the CR
(RETURN) key is required to return to the
Down Load Menu.
If a problem is encountered during down
load, the display shown (or one similar to it)
is provided.
Depression of the CR
(RETURN) key is required to return to the
Down Load Menu.
It is recommended that the RS-232C cable
between the LCR-E ETU and the computer
be checked prior to doing a down load or up
load.
2. Up Load Mode
l Selection of up load mode results in the menu
display shown:
SAMPLE LCD INDICATIONS
***DOWN LOAD***
1 AREA CODE TABLE
6 EXTRA CODE TABLE
2 WEEKLY SCHEDULE
7
OFFICE CODE TABLE
3 DAILY SCHEDULE
8
HOME NPA CODE
4 ROUTE ADVANCE
5 ROUTE TABLE
10
ALL DATA
ENTER MENU NO. q
AREA CODE TABLE DOWN LOAD START
0
I
OFFICE CODE TABLE DOWN LOAD START
ALL DATA UP LOAD START
AREA CODE TABLE DOWN LOAD START
NORMAL END 4
AREA CODE TABLE DOWN LOAD START
ABNORMAL END
LINE TROUBLE
***UP LOAD***
1 AREA CODE TABLE
6 EXTRA CODE TABLE
2 WEEKLY SCHEDULE
7 OFFICE CODE TABLE
3 DAILY SCHEDULE
8 HOME NPA CODE
4 ROUTE ADVANCE
5 ROUTE TABLE
10 ALL DATA
1 ENTER MENU NO. q
700 - 36