user manual

ND-20292
CHAPTER 7
APRIL, 1990
A.
Area Code Table Modify
With the Modify Menu displayed, depress 1,
then depress CR (RETURN).
The computer loads the area code table data
from the floppy disk and, when done, displays
the Area Code Table Modify display as shown.
At this time, enter the tenant number for the
area code assignments to be made. Depress a
number l-3, then depress CR (RETURN).
NOTE: Although it is possible to enter 0 as a tenant
number, this assignment has no function
when used with the Electra Ma&II and will
result in no operation or incorrect operation
of the LCR.
Type in the area code to be assigned, then
depress CR (RETURN). The example shows
the display for selection of tenant 1 and area
code 200.
Based on the area code dialed, the LCR
determines which tables should be examined.
The first decision that must be made is the
type of table to be routed through. Two types
of tables can be selected based on the area code.
The first type is the weekly schedule tables.
The second type is the route advance tables.
Depress the Space Bar to select the type of
table. The first depression of the Space Bar
causes the display to show WEEKLY as the
selected table type.
Depressing the Space Bar again selects
ROUTE ADVANCE as the selected table type.
After selecting the table type, depress the
Cursor Down key to get to the Table No. line
and enter the desired table number (for the
table type selected). The example shows the
selection of WEEKLY table number 10. A
maximum of sixty four tables can be selected
(00-63) for either WEEKLY or ROUTE
ADVANCE.
SAMPLE LCD INDICATIONS
***AREA CODE TftBLE MODIFY***
TENANT NO. .
***AREA CODE T@BLf MODIFY***
TENANT NO.
AREACODE j 0
***AREA CODE ,,BL: MODIFY***
TENANT NO.
AREA CODE i 200
TABLE NAME :
******
TABLE NO. : **
***AREA CODE TABLE MODIFY***
TENANTNO. ? 1
AREA CODE ? 200
TABLE NAME :
TABLE NO. :
EEEKLY
***AREA CODE TABLE MODIFY***
TENANTNO. ? 1
AREA CODE
? 200
TABLE NAME :
WEEKLY
TABLE NO. : 10
Once the above steps are completed, two
options are available. If corrections are
required, use the Cursor Up key to return to
the line to be changed. If no changes to the
data are required, depress the CR (RETURN)
and the display increments to the next area
code. Selection of a new area code can be made
at this time or depress CR (RETURN).
700 - 39