user manual

ND-20292
CHAPTER 7
APRIL, 1990
NOTE 1:
NOTE 2:
NOTE 3:
The displays shown are typical of what may
be seen during the clearing process. The
blocked off area is replaced with the name of
the selected table name. Due to the large
memory used in the office code table, when
it is cleared the display will show darkened
cursor blocks to indicate the progress of the
clearing process.
At the end of the clearing process, depress
CR (RETURN) to get back to the System
Data Clear Menu.
Refer to the table of errors (elsewhere in this
chapter) for further guidance if a problem is
encountered.
8. System Control Mode
The LCR Main Menu provides an option to restart
the LCR-E ETU. This option is made available to
allow resetting the LCR-E ETU without affecting
the rest of the system (in other words a CPU-EC 1
reset is not necessary to reset the LCR-E ETU).
Under normal conditions this option is not used.
To use this option the following procedure is
required.
With the LCR Main Menu in the display, enter 10,
then depress RETURN. The display shown is
provided.
If no problem is encountered during the restarting
process, the display shown is provided.
If a problem is encountered during the restarting
process, the display shown is provided.
NOTE 1:
After the restarting process is completed,
depress CR (RETURN) to get back to the
LCR Main Menu.
SAMPLE LCD INDICATIONS
PHASE EXECUTING 0
PHASE EXECUTING
NORMAL END 4
PHASE EXECUTING
ABNORMAL END
LINE TROUBLE 4
700 - 56