Electronics America Server User Manual

Configuring Your System 3-41
CONFIGURING SYSTEM BOARD JUMPERS
With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in
the server against access from unauthorized users. When you forget the passwords, however, you
may want clear them. The following describes how to clear these passwords. You can also use
the following procedure to clear the CMOS data in the server.
IMPORTANT:
Clearing the CMOS data resumes the factory-set
configuration data. After clearing the CMOS contents, change the setting
as shown below. This setting is necessary for operating the server
correctly.
!
Select [Advanced] → [Peripheral Configuration] → [Legacy USB
Support] → [Disabled].
!
Select [Boot] → [Boot Device Priority] → [ATAPI CD-ROM Drive]
→ [1st Boot Device].
!
Select [Boot] → [Boot Device Priority] → [Removable Drive] → [2nd
Boot Device].
!
Select [Boot] → [Hard Disk], and set the boot order.
To clear passwords or the CMOS data, use the jumper switch on the system board of the server.
The following figure illustrates the jumper switch location.
IMPORTANT:
Do not change any other switch settings. Any change may
cause the server to fail or malfunction.
PSWD Clear: Pin for protecting/clearing the password
CMOS Clear: Pin for protecting/clearing the CMOS
contents (The figure shows the factory-set.)
Clears the password.
Clears the CMOS contents.