Electronics America Server User Manual

Installing the Operating System 4-51
16. The system displays the message:
“Password”
Enter appropriate choices.
17. The system displays the message:
“The Installation can now proceed unattended”
Select OK and Press ENTER.
18. Somewhere toward the end of the installation, the following messages are
displayed:
Configuring the kernel driver installation…
Press ENTER to continue:
Press ENTER to continue.
19. When the system has completed its installation, you will see the following
message:
Installation and initial configuration of SCO OpenServer Rel. 5.0.X
Enterprise System is complete…
Press ENTER to continue:
Press ENTER to continue. The system displays:
** Safe to Power Off **
- or -
** Press any Key to Reboot **
20. If a SCSI tape drive is attached to channel B of the Adaptec 7899 onboard
controller, perform the following steps. This will generate a new idscsi file to
correct a kernel/link problem. Otherwise, go to step 24.
21. Start the newly installed system.
22. Insert the Adaptec Ultra 160 Driver for SCO OpenServer 5.0.X disk, which has an
additional file that must replace an existing file in the operating system.
23. Log into "Root" and from the "Unix" window issue the following:
"mount -f/dev/fd0/mnt."
"cp/mnt/idscsi/etc/conf/bin"