Electronics America Server User Manual

6-8 Troubleshooting
On-screen error message Description Action
8194 CPUID, Processor
Family are different
The processor type does not
match the value in the
installed processor [1, 2].
8195 Front Side Bus Speed
mismatch. System
Halted
The front side bus speed
does not match the value in
the installed processor [1,
2].
Securely install the processor.
Contact your service representative
to replace the processor or system
board.
8196 Processor Model are
different
The processor model does
not match the value in the
installed processor [1, 2].
8197 CPU Speed mismatch The processor clock speed
does not match the value in
the installed processor [1,
2].
Install processors under the same
specification.
8300 Baseboard
Management Controller
failed to Function
The baseboard
management controller does
not function.
8301 Front Panel Controller
failed to Function
The front panel controller
does not function.
8305 Hotswap Controller
failed to Function
The hot swap controller
installed on the SCSI back-
plane (HSBP) does not
function.
Contact your service representative
to replace the system board.
8420
Intelligent System
Monitoring Chassis
Opened
The top cover is not installed
correctly.
Install the top cover correctly.
84F1 Intelligent System
Monitoring Forced
Shutdown
The system was forcibly
shut down.
Confirm that the system starts
normally. If the system is in
abnormal state, contact your
service representative to replace
the system board.
84F2
Server Management
Interface Failed
A server management
interface failure occurred.
Contact your service representative
to replace the system board.
84F3 BMC in Update Mode
The baseboard
management controller is in
update mode.
84F4 Sensor Data Record
Empty
There is no sensor data
record.
Ask your service representative for
maintenance.
84FF System Event Log Full The event log is full. Clear the event log by using the
BIOS SETUP utility. If the error is
not eliminated, contact your service
representative to replace the
system board. The error message
is displayed periodically if
ESMPRO is not installed. The
event log must be cleared
periodically.