Electronics America Server User Manual

6-24 Troubleshooting

Not more than two Network adapter is connected, but the detailed specification of the protocol are all set by

default.(e.g. Specified IP Address on TCP/IP, but DHCP is specified)

Are you specifying more than two protocols?

In this case, the situation will be the same as connecting more than two Network adapter,

so the detailed specification of the protocol are all set by default.

Re-specify the details from Control Panel after starting the OS.

Error message appeared during the installation, and ESMPRO Agent and IIS(Internet Information Server) can

not be installed.

Install ESMPRO Agent and IIS after completing the installation of Windows NT 4.0.

More than one network boards are connected by the specification of setup information, but TCP/IP can not be

specified for each network adapter.

Install with DHCP specified. In case you set formal IP configuration, first install with

DHCP specified and re-specify the value from Control Panel after the installation.

Connected more than two network boards and installed network drivers, but only one network board is

normally working after starting Windows NT 4.0.

Modify the specification of network adapter from Control Panel.

Following message appeared during the installation:

Lacking the quarter of system registry.

To increase the registry quarter, run [System] in Control Panel and click [Virtual Memory].

After logging on, follow the message to modify the value of registry quarter.