Electronics America Server User Manual

Setting Up Your System 2-3
SELECTING A SITE
Installation
Your server unit should be mounted in a standard EIA 19-inch rack cabinet.
Rack Installation
Refer to the documentation attached to the rack or contact your service representative for rack
installation of the server unit.
WARNING
Observe the following instructions to safely use the server. Failure to follow
these instructions may result in death or serious personal injury.
■
Do not use the server in any unauthorized place.
■
Do not connect the ground line to a gas pipe.
CAUTION
Observe the following instructions to safely use the server. Failure to follow
these instructions may cause a fire, personal injury, or property damage.
■
Do not carry or install the server by a single person only.
■
Do not install the server where the load may be concentrated on a specific
point.
■
Do not install any component on the server by a single person only.
■
Do not pull a device out of the rack if the rack is unstable.
■
Do not leave more than one device pulled out from the rack.
■
Do not exceed the power rate of the wiring.