Release Notes

4 Express5800/120Ed System Release Notes
!
EXPRESSBUILDER operates in floppy emulation mode. The emulated
floppy drive portion of your system CD-ROM is designated Drive A and the
remaining portion(s) of the CD-ROM is designated Drive Q. Your system
diskette drive is Drive B. After creating the Off-line Maintenance Utility
diskette, EXPRESSBUILDER prompts you to remove the diskette from
Drive B. At this prompt, remove the diskette from your diskette drive.
SCO
The following advisory applies when using SCO 5.05:
!
During the installation of SCO or any time thereafter when booting SCO a
warning message may appear as follows:
WARNING: Cannot connect to APM, error 0x0036 System loaded, press
<Return> to start:
To prevent the WARNING message from appearing, boot the system to
single-user Mode. Edit the /etc/default/boot file. Add "apm.check=no" to the
end of the line indicated by the "DEFBOOTSTR=" entry.
System Hardware
The following advisory applies to the USB ports on your server's external device
connectors.
!
The factory standard default value of the USB ports on your server is
"Disabled". To enable them, the USB Controller feature in the Peripheral
Configuration Submenu of the BIOS Setup Utility "BIOS Setup
Configuration Settings" must be changed to "Enabled". Refer to
Chapter 3 of your User’s Guide. Your User’s Guide is included on
EXPRESSBUILDER.
The following advisory applies to the Plug and Play feature of your server's I/O
expansion boards.
!
The Windows 2000 Operating System requires that your server’s PnP O/S
feature be enabled. Before installing the Windows 2000 Operating System,
run the BIOS Setup Utility as described in Chapter 3 of your User’s Guide,
to verify the PnP O/S feature is enabled. Your User’s Guide is included on
EXPRESSBUILDER.