Express5800/120Ee DDS-4 DAT Tape Drive/ SCSI Controller Installation Insert PN: 455-01660-000
Proprietary Notice and Liability Disclaimer The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Solutions (America), Inc. and/or its licensors. NEC Solutions (America), Inc. and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use, and sales rights thereto, except to the extent said rights are expressly granted to others.
Contents Introduction ..................................................................................................................1 Unpacking the Option...................................................................................................1 General Information .....................................................................................................1 Static Precautions .........................................................................................................
Introduction This installation insert provides information for installing the Sony™ SDT-11000 DDS-4 DAT Tape Drive and Adaptec® SCSI controller into your Express5800/120Ee Server. Read this procedure in its entirety before performing the installation to become familiar with the components and the sequence of steps you will perform. Unpacking the Option When you receive your option, inspect the shipping container prior to unpacking.
! CAUTION Operating your system with the side panels removed can damage your system components. For proper cooling and airflow, always replace the side panels before powering on your system. Static Precautions An electrostatic discharge (ESD) can damage disk drives, option boards, and other components. You can provide some ESD protection by wearing an antistatic wrist strap attached to chassis ground when handling system components. Electronic devices can be easily damaged by static electricity.
Removing the Side Panels To install this option in your system, you must remove both the left and right side panels. Use this procedure for removing the side panels. ! CAUTION For proper cooling and airflow, do not operate the system with the side panels removed. Always replace the panels before powering on the system. To remove the side panels: 1. Ensure the server is powered off and disconnected from the ac wall outlet. 2.
Installing the SCSI Controller Board 1. Ensure the server is powered off it is disconnected from the AC power source. 2. Tilt the server on its side. 3. From the top of the system count down to the fourth expansion slot cover. ! CAUTION Before performing the next step, be sure you are removing th the 4 expansion slot cover (as counted from the top of the system). Once expansion slot covers are removed from the system, they cannot be replaced. 4.
6. Holding the board by its top edge or upper corners, firmly press the board into an expansion slot 3 on the system board. The tapered foot of the option board-retaining bracket must fit into the mating slot in the expansion slot. See Figure 3. Figure 3. Installing an Option Board 7. Align the rounded notch in the retaining bracket with the threaded hole in the expansion slot frame. The retaining bracket fits into the space that was occupied by the expansion slot cover. 8.
Figure 4. Removing the Front Panel Removing the EMI Shield and Filler Panel 1. Ensure the server is powered off it is disconnected from the AC power source. 2. The filler panels are attached to the front cover. Locate the filler panel covering the bay into which you are installing DDS-4 device. The filler panel is released by pressing on its tabs located on the inside of the front panel. See Figure 5. Figure 5.
3. Locate the EMI (Electromagnetic Interference) shield covering the bay into which you are installing the DDS-4 device The EMI shield is attached to the front of the chassis with two screws. Remove the screws and EMI shield covering the bay into which you are installing a peripheral device. See Figure 6. Figure 6. Removing an EMI Shield Installing the DDS-4 DAT Tape Drive 1. Ensure the server is powered off it is disconnected from the AC power source. ! CAUTION Observe static precautions.
Power Cable Figure 7. Installing a Removable Media Device 5. Connect the P2 end of the interface ribbon cable and the power cable to the device as shown in Figure 7. 6. Replace the front panel and side panels, and power on the system.