User's Guide

10 Installing the NEC ESMPRO Agent
INSTALLING THE NEC ESMPRO AGENT SOFTWARE
To install the NEC ESMPRO Agent software, you need to know the hardware model and the
destination directory for NEC ESMPRO Agent software.
1. Insert the EXPRESSBUILDER CD into the CD-ROM drive.
2. Click on [Setup] on the EXPRESSBUILDER Master Control Menu, and select [NEC
ESMPRO] from the pop-up menu appeared.
NEC ESMPRO Setup will be displayed.
3. Click on [Agent].
4. Enter the requested information when prompted. A progress gauge displays the names of
the files being loaded and the percentage of completed installation.
IP Address Confirmation
If you have a problem with installation, confirm that cabling is connected correctly. Also verify that
IP addresses are set up correctly as follows.
1. Press the "Start" button, highlight "Programs", "Accessories" and "Command Prompt".
2. Enter the following command, where xxx.xxx.xx.x is the system IP address.
ping xxx.xxx.xx.x
If TCP/IP is set up correctly, your screen will display four lines similar to the following.
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
If TCP/IP is not set up correctly, your screen will display four lines similar to the
following.
Request timed out.
Request timed out.
Request timed out.
Request timed out.
If your system displays an invalid destination message, check cabling and the IP address
assigned before continuing.