User Guide

6-4 Installing and Using Utilities
NEC EXPRESSBUILDER for DOS-Based with Local Console
This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based with
local console.
Starting NEC EXPRESSBUILDER
The following procedure instructs you to start NEC EXPRESSBUILDER.
IMPORTANT: Do not remove the NEC EXPRESSBUILDER CD-
ROM while NEC EXPRESSBUILDER is running.
1. Turn on peripheral devices and the server in this order.
2. Insert the NEC EXPRESSBUILDER CD-ROM supplied with your server into the CD-
ROM drive of your server.
3. Ensure that the floppy disk drive is empty.
4. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NEC
EXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)
NEC EXPRESSBUILDER boots up displaying the top menu.