Installation & Configuration Guide

85
Step 4
Use the following command to check the status of LAN card:
vndctl status 7
“ha0” indicates the interface name (ha0) which is used to set dual configuration to
the two LAN cards and then virtually treats them as one LAN card.
Step 5
Use the following command to set the IP address:
vndctl config 7
Step 6
The screen will be switched to the entry screen. (netconfig command is being
executed.)
The message “Would you like to set up networking?” will appear. Click “Yes” to
continue.
Note:
Do not select DHCP here.