User's Guide

3-18 Configuring Your System
SCSI Bus Settings Submenu
Feature Choices or Display Only Description Your Setting
SCSI Bus SCSI ID
0, 1, 2, 3, 4, 5, 6, 7, 8, 9,
10, 11, 12, 13, 14, 15
Specify the SCSI bus ID value.
Value 7 is set for SCSI Bus 0 and
value 6 is set for SCSI Bus 1.
SCSI Bus Reset
Enabled
Disabled
Make the reset valid or invalid for
SCSI buses.
SCSI Bus Reset
Delay
0, 1, 2, 3, 4, 5, 6, 7, 8, 9,
10, 11, 12, 13, 14, 15
Factory set. Do not change.
SCSI Bus
Termination
Auto
High only
Disabled
Enabled
Set the termination resistance of
the SCSI bus.
Autoconfigure SCSI Device Submenu
When "Autoconfigure SCSI Device" is selected the screen for setting the
information on the device connected to the host adapter appears.
The parameters (choices) and their default settings are the same as those listed
in the table for "SCSI Device Settings."
Notes: Always check the SCSI ID of the target device
before changing the SCSI bus settings and SCSI IDs.
The default settings at shipment are identical for both SCSI
bus 0 and SCSI bus 1.
The following items can be changed by setting the Adapter
Configuration in "SCSI Device Setting" to Manual.
- Enable Device
- Enable LUNs
- Negotiate Wide
- Negotiate Sync
- Tagged Queuing
- Sync Offset
-Sync Period
- Exec Throttle